Oil Pressure Adjustment

[sewalker]

Hello,
I purchased an oil pressure regulating kit from Moyer a year ago but am having a problem with total replacement. I replaced the spring but the original ball that regulates the pressure I have been unable to take out and replace with the cone shaped piece. The ball was wedged tightly, I assume due to sludge buildup, but I was able to work it free. I have never been able to extract it even though I am now able to adjust the pressure. I agree and believe that the new attachment should better regulate the oil pressure as now the pressure does pulsate quite a bit over various temperatures and rpm. Are there any suggestions as to how to extract the ball?
Thanks,
Stan

[WestDock]

Stan,

I had a similar problem getting the ball out. I tried a strong pencil magnet at first, but then resorted to kicking the engine over a few times (raw water intake closed of course) and the ball rolled out.

Once I installed the new (earlier style) regulating kit I was able to adjust to a steady 40PSI.

Good luck

Regards,
B

Hello,
I purchased an oil pressure regulating kit from Moyer a year ago but am having a problem with total replacement. I replaced the spring but the original ball that regulates the pressure I have been unable to take out and replace with the cone shaped piece. The ball was wedged tightly, I assume due to sludge buildup, but I was able to work it free. I have never been able to extract it even though I am now able to adjust the pressure. I agree and believe that the new attachment should better regulate the oil pressure as now the pressure does pulsate quite a bit over various temperatures and rpm. Are there any suggestions as to how to extract the ball?
Thanks,
Stan

[sewalker]

Thanks B,
I will try your suggestion.

Stan :)