Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Discussion Topics > Reversing Gear

Thread Tools Display Modes
  #1   IP:
Old 02-23-2017, 07:11 PM
sdemore sdemore is online now
Senior Member
Join Date: Nov 2016
Location: Pasadena, MD
Posts: 32
Thanks: 17
Thanked 1 Time in 1 Post
Clutch Sub-Assembly Issues

In rebuilding my basket case engine, I am looking at the reversing gear. I actually have two of them, one assembled, but pretty badly corroded and a spare with a corroded case, but the reversing gear assembly looking ok. I removed the corroded unit from the good case and compared the two assemblies. In both cases, rust is falling out of the end with the pinion gears and I can't get anything in there to turn.

My question is, can I disassemble the clutch sub-assembly to get access to the pinion gears, without pressing out the tail shaft? I don't really want to do that, so have the whole thing soaking in a bucket of oil while await your answers.

Reply With Quote
  #2   IP:
Old 02-24-2017, 03:08 PM
Administrator's Avatar
Administrator Administrator is online now
MMI Webmaster
Join Date: Oct 2004
Location: Chestertown, MD (Langford Creek)
Posts: 1,685
Thanks: 485
Thanked 116 Times in 51 Posts

I don't remember similar questions. You may want to give Don a call.

Moyer Marine Inc.
Reply With Quote
The Following User Says Thank You to Administrator For This Useful Post:
sdemore (02-24-2017)

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Broken pressure plate on reverse gear clutch assembly seapadrik Reversing Gear 8 08-31-2012 02:53 PM
Forward and Reverse Gear Adjustment Issues CraigRun Reversing Gear 12 05-17-2012 08:15 PM
difficulty moving adjusting plate in clutch assembly tartan27hull157 Reversing Gear 0 08-08-2010 09:11 PM
Pressure on the drive lever to fully engage? Andy Mck Reversing Gear 6 10-08-2009 09:33 AM

All times are GMT -5. The time now is 01:01 AM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2017, vBulletin Solutions, Inc.

Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2017 Moyer Marine Inc.

All Rights Reserved