Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Discussion Topics > Ignition System

Reply
 
Thread Tools Display Modes
  #1   IP: 69.85.235.235
Old 10-05-2017, 03:31 PM
Golfdad75 Golfdad75 is offline
Senior Member
 
Join Date: Sep 2014
Posts: 63
Thanks: 2
Thanked 0 Times in 0 Posts
Battery Switch?

For the last four years or so my keysometimes will not turn the engine over. Either it will on subsequent tries or I go down and switch the battery to all. But if I switch it to the house battery only it does the trick.When I turn the battery switch it never fails. Lately it has happening more and more and I want to fix it, I am thinking my switch is the problem. Any thoughts
Reply With Quote
  #2   IP: 71.118.13.238
Old 10-05-2017, 05:04 PM
Dave Neptune Dave Neptune is offline
Afourian MVP
 
Join Date: Jan 2007
Location: Lake Arrowhead Ca.
Posts: 3,674
Thanks: 211
Thanked 204 Times in 144 Posts
G, check the connections and grounds on the batteries as well as the connections to and from the switch.

With some help you could check for voltage drops that could well point to the switch. They do go bad from time to time after many years of service.

The key switch is also suspect if your start and/or house battery are week too.

Dave Neptune
Reply With Quote
  #3   IP: 71.178.83.76
Old 10-05-2017, 11:23 PM
sastanley's Avatar
sastanley sastanley is offline
Afourian MVP
 
Join Date: Sep 2008
Location: Solomons, MD
Posts: 6,309
Thanks: 388
Thanked 240 Times in 185 Posts
GD75, Any connection is suspect, but if one battery works and all or the other doesn't, focus on the bad battery connections, as Dave noted.

Just need to spend an afternoon cleaning everything up! You can get cheap CRC electrical cleaners in a spray can from Lowe's or Home Depot. Physical scraping with a brass brush does not hurt either to remove any corrosion. I've found that good solid connections tend to not corrode as much as those that might be loose.
__________________
-Shawn
"Twice Around" - '77 Catalina 30, #511 with original A-4 & MMI manifold.
Great fall sailing!!

http://www.moyermarine.com/forums/signaturepics/sigpic3231_6.gif
Reply With Quote
  #4   IP: 32.211.28.40
Old 10-08-2017, 05:09 PM
Al Schober's Avatar
Al Schober Al Schober is offline
Afourian MVP
 
Join Date: Jul 2009
Location: Uncasville, CT
Posts: 1,233
Thanks: 4
Thanked 110 Times in 99 Posts
GD,
When you get your connections clean, put a little silicone grease on them when you make them up. It will keep the connections clean longer by keeping moisture out of the interface. I use Dow Corning #111 - a 5 oz tube from McMaster will last a lifetime.
A good check of your A/B switch is to watch your cabin lights as you cycle the switch. If the lights flicker, the switch is going bad. If the engine is running, a bad A/B switch can fry your alternator.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Battery Switch Question Loki9 Electrical 3 04-21-2012 04:55 PM
Alternator Issues Capt Don Q Electrical 9 12-04-2009 01:55 AM
ACR and Atomic 4 rigspelt Electrical 69 07-13-2009 03:58 PM
Battery switch starts engine!? gabe522 Ignition System 12 06-26-2009 10:26 AM
Battery Switch: Field Disconnect Protection SEMIJim Electrical 12 04-30-2009 01:55 PM


All times are GMT -5. The time now is 09:12 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2017, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2017 Moyer Marine Inc.

All Rights Reserved